standard sata ahci controller driver windows 7

If the BSOD in your case falls into any of these categories, you can apply the appropriate solutions below to fix this BSOD. We’ve listed the most common I/O status codes above. In the case of older Parallel ATA (IDE) drives, it can also indicate an incorrect master/slave drive configuration. This status code indicates cable or drive failure.

Additionally, defective cabling or bad termination on SCSI devices can also lead to this status code. Two devices are trying to use the same IRQ. STATUS_DISK_OPERATION_FAILED (0xC000016A).If there’s improper termination or the controller doesn’t see the hard disk, that can also lead to this status code. The device is likely not connected due to loose or defective cables. STATUS_DEVICE_NOT_CONNECTED (0xC000009D).STATUS_INSUFFICIENT_RESOURCES (0xC000009A).Here are some common status codes for Parameter 2: By checking Parameter 2, you can narrow down the cause a lot more.

The KERNEL_DATA_INPAGE_ERROR occurs as a result of defective hardware (storage drives, cabling, RAM), a damaged file system, or a virus infection.

Standard sata ahci controller driver windows 7